Aurorisk FR

Chapter 1 · Lesson 1.4

Harmonised standards: types A, B and C

The essential requirements say what to achieve, not how. Harmonised standards, whose reference is published in the Official Journal of the Union, propose ways of achieving it; applying them gives a presumption of conformity with the requirements they cover.

TypeContentExamples
A (basic standards)Design and risk assessment principles applicable to all machinesISO 12100
B (generic standards)One safety aspect (B1) or one type of safeguard (B2), usable on many machinesISO 13849-1 (control systems), ISO 13855 (positioning of safeguards), ISO 13857 (safety distances), ISO 14119 (interlocking), ISO 13850 (emergency stop), IEC 60204-1 (electrical equipment)
C (machine-specific standards)Detailed requirements for a family: presses, machine tools, robots, conveyors…Standards specific to press brakes, industrial robots, etc.
The three types of harmonised machinery standardsAt the top, type A standards, principles applicable to all machines, such as ISO 12100. In the middle, type B standards, on a safety aspect or device. At the bottom, type C standards, specific to a family of machines, which take precedence when they exist.Type A: Basic safety standardsISO 12100: principles, risk assessmentType B: Generic safety standardsISO 13849-1, ISO 13855, ISO 13857, ISO 14119, IEC 60204-1…Type C: Machine-specific standardspress brakes, robots, conveyors…: take precedence when they exist
From general to specific: first look for the machine's C standard, then complete with A and B standards for what it does not cover.

How to use them

  1. Look for the type C standard of the machine. If it exists and covers the hazard, it takes precedence: it was written for that family.
  2. Complete with type A and B standards for what the C standard does not cover, or if there is no C standard.
  3. Check the up-to-date list of harmonised standards: a standard not cited in the Official Journal, or withdrawn, does not give the presumption of conformity. With the Regulation, new harmonised standards will be published.
A standard is not an obligation… but

The manufacturer may meet the essential requirements otherwise than with a harmonised standard; they must then demonstrate that they do so. In practice, departing from a C standard without a solid justification is very risky.

Key takeaway
  • Type A: principles (ISO 12100); type B: aspects and devices; type C: families of machines.
  • The C standard takes precedence when it exists and covers the hazard.
  • Only harmonised standards cited in the Official Journal give the presumption of conformity.